SERIES 60 SERVICE MANUAL 1.15.3 Installation of Crankshaft Pulley Install the crankshaft-mounted pulley as follows: 1. If removed, install the flywheel lock (J–36375–A)to the inspection plug hole in the bottom of the flywheel housing. See Figure 1-243. 2. Thread the center screw of the tool until the tip of the tool rests between two teeth of the flywheel ring gear. NOTE: It may be necessary to bar the engine slightly using engine barring tool (J–36237) so that the tool center screw is exactly between two teeth. 3. Finger-tighten the knurled knob. NOTICE: Use care when installing the crankshaft pulley as the vibration damper, which is slip fitted over a pilot diameter of the crank, may come off.
If the damper is allowed to fall, internal damage to the damper will result. 4. Install two guide studs to two of the holes in the crankshaft that are 180 degrees apart. 5. Install the vibration damper over the guide studs and onto the crankshaft. Refer to section 1.14.3. 6. Install the crankshaft pulley over the guide studs and onto the crankshaft. The crankshaft pulley may be installed in any position. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-261