1.15 CRANKSHAFT PULLEY NOTICE: Crankshaft pulley and spindle mounting blots are considered single-use items and must not be reused. Always use new bolts when mounting the crankshaft pulley or spindle. Reusing bolts may result in excessive bolt stretch during installation, leading to breakage or loss of bolt torque and loosening during engine operation, which may cause severe damage. 7. Install four new special crankshaft pulley-to-crankshaft attaching bolts with hardened washers installed, through the pulley and damper and into the crankshaft. Finger tighten the bolts. See Figure 1-246. Figure 1-246 Crankshaft Pulley Mounted Directly to the Crankshaft 8. Remove the two guide studs. 9.
Install the remaining two new special crankshaft pulley-to-crankshaft attaching bolts with hardened washers installed. 10. Torque the six new special bolts to 182-210 N·m (134-155 lb·ft). Proceed in a clockwise direction until all bolts are torqued. 11. Remove the flywheel lock tool. 12. Install the pipe plug to the inspection hole in the flywheel housing. 13. Install the drive belts to the crankshaft pulley. Adjust the belt tensions to the specifications. Refer to section 14.6.9. 14. Install any other components that were removed for this operation. Install the spindle mounted pulley and hub assembly as follows: (Rev. 2005) All information subject to change without notice.
1-262 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION