Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 1. Install the flywheel lock (J–36375–A). See Figure 1-247. Figure 1-247 Flywheel Lock 2. Thread the center screw of the tool in until the top of the tool rests between two teeth of the flywheel ring gear. 3. Finger tighten the knurled knob. NOTE: It may be necessary to bar the engine over using the crankshaft pulley bolt so that the tool center screw is exactly between two teeth. 4. Install two guide studs to two of the holes in the crankshaft that are 180 degrees apart. 5. Install the vibration damper over the guide studs and onto the crankshaft. Refer to section 1.14.3. All information subject to change without notice. (Rev.

2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-263