SERIES 60 SERVICE MANUAL 1. Bolt (12) 4. Flywheel Housing 2. Scuff Plate 5. Crankshaft 3. Flywheel 6. Ring Gear Figure 1-250 Typical Flywheel Assembly (Diesel) A steel ring gear, which meshes with the starting motor pinion, is shrunk onto the rim of the flywheel. The flywheel is machined to provide true alignment with the clutch. The clutch plate, if used, is bolted to the flywheel with 3/8 in.-16 bolts. The flywheel must be removed for service operations such as replacing the starter ring gear, crankshaft oil seal, crankshaft or the flywheel housing. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-267