1.16 FLYWHEEL 1.16 FLYWHEEL The flywheel is attached to the rear end of the crankshaft with twelve bolts. The bolt holes in the crankshaft and flywheel are equally spaced. The flywheel is not indexed to the crankshaft, and may be installed in any position. A scuff plate is used between the flywheel and the bolt heads to prevent the bolt heads from scoring the flywheel surface. See Figure 1-249 for a typical Series 60G flywheel assembly or see Figure 1-250 for a typical diesel flywheel assembly. 1. Bolt 5. Crankshaft 2. Scuff Plate 6. Flywheel Housing Spacer 3. Flywheel 7. Ring Gear 4. Flywheel Housing Figure 1-249 Typical Flywheel Assembly (Series 60G Engine) (Rev.
2005) All information subject to change without notice. 1-266 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION