Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 7. Install four new special crankshaft pulley spindle-to-crankshaft attaching bolts with hardened washers installed. 8. Remove the two guide studs. 9. Install the remaining two new special crankshaft pulley spindle-to-crankshaft attaching bolts with hardened washers installed. 10. Torque the six new special bolts to 182-210 N·m (134-155 lb·ft). Proceed in a clockwise direction until all bolts are torqued. 11. With the pulley properly supported, install the bolt and washer and pull the pulley to the spindle. 12. Torque the center bolt holding the pulley to the spindle to 610 N·m (450 lb·ft). 13. Remove the flywheel lock tool. 14.

Install the pipe plug to the inspection hole in the flywheel housing. 15. Install the drive belts to the crankshaft pulley. Adjust the belt tensions to the specifications. Refer to section14.6.9. 16. Install any other components that were removed for this operation. 17. Refer to section 12.3 for verification of proper crankshaft pulley installation. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-265