SERIES 60 SERVICE MANUAL 1.16.2 Removal and Cleaning of Flywheel Precleaning is not necessary. Remove the flywheel as follows: 1. Remove the inspection plug in the bottom of the flywheel housing. 2. Install the flywheel lock (J–36375–A). See Figure 1-234. 3. Thread the center screw of the tool in until the tip of the tool rests between two teeth of the flywheel ring gear. NOTE: It may be necessary to bar the engine over (using the square hole in the middle of the crankshaft pulley) so that the tool center screw is exactly between two teeth. 4. Finger-tighten the knurled knob. 5. Remove eleven of the twelve flywheel attaching bolts, leaving one bolt at the 12 o'clock position. 6.
Install two flywheel guide studs (J–36235) through the flywheel and into the crankshaft at the 3 and 9 o'clock positions. See Figure 1-252. Figure 1-252 Flywheel Guide Studs All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-269