1.16 FLYWHEEL 1.16.3 Installation of Flywheel Install the flywheel as follows: 1. Install two flywheel guide studs (J–36235) into two of the tapped holes in the crankshaft at the 3 and 9 o'clock position. 2. Attach the flywheel lifting tool and, using a chain hoist, position the flywheel in the flywheel housing. Align the flywheel bolt holes with the crankshaft bolt holes. NOTICE: A new scuff plate must be used whenever the flywheel is removed. Failure to replace the scuff plate may cause the flywheel bolts to loosen, even when torqued correctly. 3. Using a new scuff, install two bolts with International Compound #2® (or equivalent) through the plate 180 degrees from each other. 4.
Install the flywheel lock (J–36375–A). See Figure 1-234. 5. Remove the flywheel lifting tool and guide studs. 6. Apply International Compound #2® (or equivalent) to the threads and to the bolt head contact area (underside) of the remaining bolts. The bolt threads must be completely filled with International Compound #2® (or equivalent). Any excess must be wiped off. See Figure 1-255. Figure 1-255 Flywheel Bolt Preparation NOTE: International Compound #2® or equivalent must never be used between two surfaces where maximum friction is desired, as between the crankshaft and the flywheel. 7. Install the bolts and torque them to 75 N·m (55 lb·ft). (Rev.
2005) All information subject to change without notice. 1-272 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION