Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 1.16.2.1 Inspection of Flywheel Inspect the flywheel as follows: 1. Inspect the clutch contact base of the flywheel. [a] Check clutch contact base for scoring, wear, or cracks. [b] The flywheel may be refaced, if the clutch contact face is scored or worn. NOTE: Do not remove more than 0.508 mm (0.020 in.) material from the flywheel. Maintain all of the radii when resurfacing. [c] The flywheel must be replaced, if the clutch contact face shows cracks. 2. Inspect the ring gear. [a] Check ring gear for excessively worn or damaged gear teeth. [b] If damaged gear teeth are detected, replace the ring gear. Refer to section 1.17.2. 3.

Inspect crankshaft and flywheel contact surface. [a] Check the butt end of the crankshaft and flywheel contact surface for fretting, brinelling, or burrs. See Figure 1-254. [b] Lightly stone the contact surface to remove any fretting, brinelling, or burrs. Figure 1-254 Crankshaft and Flywheel Mating Surfaces All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-271