SERIES 60 SERVICE MANUAL 1.18 FLYWHEEL HOUSING The flywheel housing is a one-piece casting mounted against the rear of the cylinder block. It provides a cover for the flywheel and serves as a support for the cranking motor and the transmission. See Figure 1-259. 1. Crankshaft Rear Oil Seal 3. Outer Bolt (4 long) 2. Inner Bolt (8 short) 4. Flywheel Housing Figure 1-259 Flywheel Housing and Related Parts The crankshaft rear oil seal, which is pressed into the housing, may be removed or installed without removing the housing. Refer to section 1.8.2. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-277