1.17 RING GEAR 1.17.3 Installation of Ring Gear Install the ring gear as follows: 1. Support the flywheel, ring gear side up, on a solid flat surface. BURNS To avoid injury from burning, use lifting tools and heat-resistant gloves when handling heated components. NOTICE: Do not under any circumstances, heat the gear over 204°C (399°F). Excessive heat may destroy the original heat treatment. Heat indicating "crayons" which are placed on the ring gear and melt at a predetermined temperature, may be obtained from most tool vendors. Use of these "crayons" will ensure against overheating the gear. 2.
Rest the ring gear on a flat METAL SURFACE, and heat the gear uniformly with an acetylene torch, keeping the torch moving around the gear to avoid hot spots. 3. Use a pair of tongs to place the gear on the flywheel with the chamfer, if any, facing the same direction as on the gear just removed. 4. Tap the gear in place against the shoulder on the flywheel. If the gear cannot be tapped into place readily so that it is seated all the way around, remove it, and apply additional heat. (Rev. 2005) All information subject to change without notice. 1-276 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION