SERIES 60 SERVICE MANUAL 1.18.2 Removal and Cleaning of Flywheel Housing Precleaning is not necessary. Remove the flywheel housing as follows: 1. If the engine is removed from the vehicle, mount the engine on an overhaul stand. Refer to section 1.1.2. 2. Drain the engine oil; refer to section 14.6.1, and remove the oil pan; refer to section 3.11.2. 3. Remove the flywheel and scuff plate. Refer to section 1.16.2. 4. Remove the four long outer bolts and the eight short inner bolts that secure the flywheel housing to the engine. See Figure 1-259. 5.
To guide the flywheel housing until it clears the end of the crankshaft, thread two guide studs (J–35785) for 12 mm bolts, or guide studs (J–43431) for 14 mm bolts, into the cylinder block. See Figure 1-261. Figure 1-261 Pilot Stud Installation NOTE: The illustration is shown with the flywheel housing already removed for clarity. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-279