1.18 FLYWHEEL HOUSING 6. Thread eye bolts into the tapped holes in the side pads of the flywheel housing. 7. Attach a suitable sling to the eye bolts and strike the front face of the housing alternately on each side with a soft hammer to loosen and work it off the dowel pins. 8. Remove and discard the crankshaft rear oil seal. 9. Remove all sealing material from the flywheel housing. Refer to section, "Cleaning" in the "General Information" section at the beginning of this manual. 1.18.2.1 Inspection of Flywheel Housing and Rear Oil Seal Area of Crankshaft Inspect the flywheel housing as follows: 1. Inspect flywheel housing for cracks and any other damage.
[a] If sealing surface is damaged, repair with emery cloth. [b] If cracked, repair is not possible. 2. Inspect the crankshaft where the rear oil seal makes contact. [a] Check for groove in crankshaft. [b] If crankshaft is grooved, install a wear sleeve over the crankshaft end. An oversized I.D. rear oil seal must be used with the rear sleeve. Refer to section 1.8.5. (Rev. 2005) All information subject to change without notice. 1-280 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION