Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 1.18.3 Installation of Flywheel Housing Install the flywheel housing as follows: 1. Apply a continuous 1.6 mm (1/16 in.) bead of Loctite® 509 Gasket Eliminator®, or equivalent, to the cylinder block where it mates with the flywheel housing. See Figure 1-262. Figure 1-262 Gasket Eliminator® Installation 2. Thread two aligning studs (J–35785) for 12 mm bolts or guide studs (J–43431) for 14 mm bolts, into the cylinder block to guide the housing in place. See Figure 1-261. 3. Support the housing and position it over the crankshaft and against the cylinder block. NOTE: Whenever crankshaft rear seal is put over the crankshaft, use crankshaft oil seal expander.

Refer to section 1.8.5. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-281