1.18 FLYWHEEL HOUSING 4. Install all of the housing bolts in their proper location, finger-tighten them. 5. Remove the pilot studs. 6. Torque the eight short and four long flywheel housing bolts using the proper tightening sequence. See Figure 1-263. [a] If the bolts are 12 mm, torque to 112-126 N·m (83-93 lb·ft). [b] If the bolts are 14 mm, torque to 160-200 N·m (118–148 lb·ft). Figure 1-263 Flywheel Housing Bolt Torque Sequence 7. Install the crankshaft rear main oil seal. Refer to section 1.8.5. 8. Install the flywheel. Refer to section 1.16.3. 9. Install oil pan; refer to section 3.11.4, and refill the engine with new oil; refer to section 14.6.1. (Rev.
2005) All information subject to change without notice. 1-282 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION