Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 1.18.3.1 Test for Flywheel Housing Bore Concentricity Check the flywheel housing bore concentricity, and bolting flange run-out with tool set (J–9737–D) as follows: 1. Thread the base post (J–9737–3, part of tool set J–9737–D) into one of the tapped holes on the outer edge of the flywheel. 2. Assemble the dial indicators on the base post with the attaching parts provided in the tool set. 3. Position the dial indicators straight and square with the flywheel housing bell face and inside bore of the bell. Make sure each indicator has adequate travel in each direction. See Figure 1-264. Figure 1-264 Measuring Flywheel Housing Bore Concentricity and Bolting Flange Run-out 4.

Tap the end of the crankshaft (not the crankshaft pulley) with a soft hammer to force it toward one end of the block to ensure end play is in one direction only. 5. Adjust each dial indicator to read zero at the twelve o'clock position. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-283