1.18 FLYWHEEL HOUSING 6. Bar the engine and rotate the crankshaft one complete revolution, taking readings at 90 degree intervals (four readings each for the bore and bolting flange face). See Figure 1-265. Figure 1-265 Flywheel Housing 7. Remove the wrench or cranking bar before recording each reading to ensure accuracy. [a] The maximum total indicator reading must not exceed 0.33 mm (0.013 in.) for either the bore or the face. [b] If the run-out exceeds the maximum limits, remove the flywheel and flywheel housing and check for dirt or foreign material between the flywheel housing and the cylinder block or oil pan. 8. Clean the mating surfaces once again.
Refer to section "General Information, Cleaning" in the beginning of this manual. 9. Install flywheel housing. Torque the eight short and four long bolts to the cylinder block using the proper tightening sequence. See Figure 1-263. [a] If the bolts are 12 mm, torque to 112-126 N·m (83-93 lb·ft). [b] If the bolts are 14 mm, torque to 160-200 N·m (118-148 lb·ft). 10. Install the flywheel. Refer to section 1.16.3. 11. Check the run-out again. If desired run-out cannot be accomplished, replace the flywheel housing. (Rev. 2005) All information subject to change without notice. 1-284 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION