Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.19 PISTON AND PISTON RING Each piston is fitted with a fire ring, compression ring, and one-piece oil control ring with expander. The fire and compression rings are installed with the "football" mark facing up, see Figure 1-271. Figure 1-271 Fire and Compression Ring Identification A one-piece oil control ring is used in the third groove. The expander is of Spira-Lox construction. The forged steel piston uses a floating piston pin which rides on the one-piece bushing pressed into the end of the connecting rod. The connecting rod and solid-core piston pin do not have drilled center orifices for lubrication.

Oil for lubrication and cooling is supplied by oil spray from piston-cooling nozzles installed at the bottom of each piston bore. During engine operation, gas loads pushing down on the piston dome are taken directly by the piston pin and connecting rod bushing. The piston skirt, being separate, is free from vertical load distortion. Thermal distortion is also reduced as the piston dome expands. As the connecting rod swings to one side on the downward travel of the piston, the major portion of the side thrust is taken by the piston skirt. (Rev. 2005) All information subject to change without notice. 1-290 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION