1.19 PISTON AND PISTON RING 3. After the three rings have been positioned in the liner, measure the ring gap of the top ring with a feeler gage. See Figure 1-277. Remove the ring from the liner after the measurement is complete. Figure 1-277 Piston Ring Gap Measurement 4. Repeat this procedure for each ring, and record your measurements. Allowable ring end gaps are listed in Table 1-5. Table 1-5 Allowable Ring End Gap On-Highway Engines 5. Refer to section 1.19.5 for assembly of rings for diesel engines or refer to section 1.19.6 for Series 60G engines. (Rev. 2005) All information subject to change without notice.
1-300 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION Ring Ring End Gap Fire Ring (2.5 mm [0.098 in.] chrome) 0.40 - 0.87 mm (0.016 - 0.034 in.) 14L Fire Ring: 3.0 mm (0.118 in.) 0.60 - 0.85 mm (0.024 - 0.033 in.) Fire Ring (3.5 mm [0.138 in.] plasma) 0.51 - 0.87 mm (0.020 - 0.034 in.) Compression Ring 0.81 - 1.31 mm (0.032 - 0.051 in.) 14L Compression Ring 0.63 - 0.98 mm (0.025 - 0.039 in.) Oil Control Ring 0.40 - 0.81 mm (0.016 - 0.032 in.) 14L Oil Control Ring 0.21 - 0.51 mm (0.008 - 0.020 in.)