Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 8. Inspect the edges of the bearings and piston dome pin bore. [a] Check the edges of the bearing and piston dome pin bore for dents and dings. [b] If any are found, it is acceptable to remove burrs at the bearings or pin bore edges by careful filing. NOTE: Remove any dirt or debris on the backs of the bearing or dome pin bore that may take up clearance required for bearing or piston pin installation. 9. If the piston pin used with a forged steel piston is replaced for any reason, the connecting rod bushing must be inspected for wear before the rod is installed. If the bushing is worn beyond limits, the connecting rod must be replaced.

Refer to section 1.19.3.1 for connecting rod bushing inspection procedure. 10. Check the cylinder liner and block bore for excessive out-of-round, taper and high spots which could cause failure of the piston. Specifications are listed in Table 1-17. 11. Check the block bore for excessive out-of-round, taper, and high spots that could cause failure of the piston. Specifications are listed in Table 1-16. 1.19.4 Assembly of Piston and Piston Rings Prior to installing the piston rings, the ring gap of each piston ring must be measured. 1. Insert the piston rings inside of the cylinder liner one at a time, using a piston dome (inserted upside down into the liner) to push the ring down.

The piston dome should be inserted into the liner, to the same depth as the ring being positioned. 2. For the oil control ring, insert the piston dome down into the liner, until the oil control ring land is just into the liner. This will ensure that the rings are parallel with the top of the liner, and that they are positioned in the liner within the normal area of ring travel. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-299