Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.19 PISTON AND PISTON RING 4. Inspect the piston pin. [a] Check the piston pin for fretting, cracking or signs of overheating. [b] If these are detected, replace piston pin. [c] Measure piston pin outside diameter. Specifications are listed in Table 1-21. [d] If piston pin is out of specifications, replace with new part. NOTE: If piston pin used with a cast iron piston is replaced for any reason, the piston pin bushing for that cylinder must also be replaced. NOTE: If the piston pin used on steel dome engines is replaced for any reason, the dome must also be replaced for that cylinder. 5. Inspect the piston pin bushings as follows:

[a] Check the piston pin bushings for scoring, pitting, flaking, cracking, excessive wear, or signs of overheating. [b] If these conditions are present, the bearings must be replaced. NOTE: On steel dome engines, if bearing replacement is necessary then the dome assembly must be replaced as well. NOTE: Early second keystroke ring (SKR) design piston domes have an integral piston pin bushing. The piston pin bushing cannot be replaced in these piston domes. If there is distress to the piston pin bushing, the entire piston dome assembly must be replaced, with current cast iron design. NOTICE:

If a piston pin bushing is replaced for any reason, the piston pin for that cylinder must also be replaced. 6. Inspect the back of the upper bushing. [a] Check the bushing for excessive fretting. [b] If excessive fretting is evident, replace all three bushings. [c] The corresponding fretting in the piston dome can be removed using crocus cloth, wet with fuel oil. 7. On steel piston engines, inspect the connecting rod bushing. [a] Check the bushing for excessive fretting. [b] If excessive fretting is evident, replace the connecting rod assembly. (Rev. 2005) All information subject to change without notice. 1-298 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION