Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL Inspect the piston and piston rings as follows: 1. Inspect the piston skirt and dome. [a] Check the skirt and dome for score marks, cracks, damaged ring grooves or overheating indications. [b] If any of these indications are present, replace the piston. NOTE: Burn spots may indicate an obstruction in the connecting rod or piston pin oil passage. 2. Inspect the tapered fire ring groove (top) in the piston dome. [a] Using the piston ring land step gage (J–35884–A) (2.5 mm ring groove) or gage (J–38609–A) (3.5 mm ring groove), check tapered fire ring groove. See Figure 1-276. [b] Insert the center tang of the tool gage into the top piston ring groove ash.

See Figure 1-276. [c] Hold the tool at a 90 degree angle to the ring groove to prevent false readings. [d] With the center tang into the ring groove as far as it will go, there should be no contact of the piston with the shoulders of the gage. If the gage makes contact at point A or point B, the fire ring groove is worn beyond usable limits. Check the groove clearance at four spots, at 90 degree intervals. Measure the ring land parallel to and at 90 degrees to the wrist pin. [e] If fire ring groove is worn beyond usable limits, replace piston dome. 1. Fire Ring Groove Figure 1-276 Checking Fire Ring Groove 3. Inspect tapered compression ring groove (second) in the piston dome.

[a] Using piston ring land step gage, check the groove as in the compression ring groove. [b] If the compression ring groove is worn beyond usable limits, replace piston dome. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-297