1.19 PISTON AND PISTON RING 1.19.3.1 Inspection of Piston and Piston Rings Clean the piston and piston rings prior to inspection as follows: NOTICE: Do not attempt to clean the piston skirt by glass beading. It will remove the tinplating. Do not refinish or polish the piston pin. 1. Clean the piston components with fuel oil. EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. 2. Dry the piston components with compressed air. 3. If fuel oil does not remove the carbon deposits, use a chemical solvent that will not harm the tinplate on the piston skirt. NOTICE:
After cleaning, do not leave glass beads in the piston dome. Do not allow the glass beading to contact any area of the piston pin bushing or pin bore. Glass beading will remove the tinplating. 4. The piston dome, including the compression ring grooves, is not tin-plated and may be wire-brushed to remove any hard carbon. Glass beading can be used to clean a piston dome. Micro Bead Glass Shot MS-M 0.0736-0.1473 mm (0.0029 -0.0058 in.) is recommended. The machine used for this process must be able to withstand air pressures of 552-689 kPa (80-100 psi). NOTE: Do not wire-brush the piston skirt. 5.
Clean the ring grooves with a suitable tool or a piece of an old compression ring that has been ground to a bevel edge. 6. Clean the inside surfaces of the piston dome and skirt and the oil relief channels in the oil ring grooves. (Rev. 2005) All information subject to change without notice. 1-296 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION