SERIES 60 SERVICE MANUAL 3. Perform the following steps on current cast iron domes: [a] Separate the piston skirt from the piston dome and mark the front of the dome ear and skirt with a paint pencil, so they can be returned to the correct location. [b] Remove the piston pin bearings, marking the front of them with a paint pencil, so they can be returned to the correct location. NOTE: Bearings are not serviced separately on steel pistons. NOTE: The lower pin bore bearings are removed from the pin bore first, by pushing the bearing legs outward by hand at the split lines from inside the dome saddle ear.
The upper bearing may be held in the bore by oil on the back of the bearing, making removal from the pin bore by hand difficult. EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. NOTICE: Prying between the bearing back and dome bore may damage the dome saddle bore or raise burrs which will make installation of new bearings difficult. DDC recommends that compressed air be directed between the dome pin bore and back of the bearing at one end until the bearing pops up out of the bearing retaining hole. All information subject to change without notice. (Rev.
2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-295