Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.20 ONE-PIECE PISTON ASSEMBLY AND PISTON RING 1.20.2 Removal and Cleaning of Piston Assembly and Piston Ring Refer to section 1.21.2 for piston and connecting rod assembly removal procedure. 1.20.3 Disassembly of Piston Assembly and Piston Ring Disassemble the piston and piston rings as follows: 1. Remove the piston rings with tool (J–8128). See Figure 1-289. Figure 1-289 Removal of Piston Rings 2. Remove oil control ring expander from oil control ring. NOTICE: The pin and piston assembly must be match-marked to assure proper position and orientation. 3.

Withdraw the piston pin and mark the front of the piston assembly with a paint pencil, so it can be returned to the correct cylinder location. NOTE: The one-piece piston assembly require the removal of the retainer before withdrawing the piston pin. (Rev. 2005) All information subject to change without notice. 1-310 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION