SERIES 60 SERVICE MANUAL 1.20.3.1 Inspection of Piston Assembly and Piston Rings Clean the piston assembly and piston rings prior to inspection as follows: NOTICE: Do not attempt to clean the one-piece piston by glass beading. Glass beading will remove the surface treatment. Do not refinish or polish the piston pin. 1. Clean the piston components with fuel oil. EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. 2. Dry the piston components with compressed air. 3.
If fuel oil does not remove the carbon deposits, use a chemical solvent that will not harm the coating on the piston assembly. However if a chemical solvent is to be used for the cleaning of the piston, remove the rings, some solvents can damage the top ring coating material. NOTICE Do not glass bead the pin bushing or pin bore. 4. The piston assembly, including the compression ring grooves, is not tin-plated and may be wire-brushed to remove any hard carbon. 5. Clean the ring grooves with a suitable tool or a piece of an old compression ring that has been ground to a bevel edge. 6. Clean the inside surfaces of the piston dome and the oil relief channels in the oil ring grooves.
Inspect the piston assembly and piston rings as follows: 1. Inspect the piston assembly. [a] Check the piston assembly for score marks, cracks, damaged ring grooves or overheating indications. [b] If any of these indications are present, replace the piston assembly. NOTE: Burn spots may indicate an obstruction in the connecting rod oil passage. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-311