1.20 ONE-PIECE PISTON ASSEMBLY AND PISTON RING 2. Inspect the piston pin. [a] Check the piston pin for fretting, cracking or signs of overheating. [b] If these are detected, replace piston pin. [c] Measure piston pin outside diameter. Specifications are listed in Table 1-21. [d] If the articulated steel piston pin is out of specification, replace with new part. NOTICE: If the piston pin used on the one-piece piston assemblies is replaced for any reason, the piston assembly must also be replaced. 3. Inspect the bushingless piston pin bore as follows. [a] Check the bushingless pin bores for scoring, pitting, flaking, cracking, excessive wear or signs of overheating.
[b] If these conditions are present the piston assembly must be replaced. 4. Inspect the edges of the piston assembly pin bore. [a] Check edges of the piston assembly pin bore for dents and dings. [b] If any are found it is acceptable to remove burrs at the pin bore edges by careful filing. 5. Inspect the connecting rod bushing. [a] Check the bushing for excessive fretting. [b] If excessive fretting is evident, replace the connecting rod assembly. NOTE: Remove any dirt or debris on the back of the piston pin bore that may take up clearance required for piston pin installation. 6.
If the piston pin used with a one-piece piston is replaced for any reason, the connecting rod bushing must be inspected for wear before the rod is installed. If the bushing is worn beyond limits, the connecting rod must be replaced. Specifications are listed in Table 1-23. 7. Check the cylinder liner for excessive out-of-round and high spots which could cause failure of the piston. Specifications are listed in Table 1-17. 8. Check the block bore for excessive out-of-round, taper, and high spots that could cause failure of the piston. Specifications are listed in Table 1-16. (Rev. 2005) All information subject to change without notice.
1-312 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION