SERIES 60 SERVICE MANUAL 1.20.4 Assembly of Piston and Piston Rings Prior to installing the piston rings, the ring gap of each piston ring must be measured. 1. Insert the piston rings inside of the cylinder liner one at a time, using a piston dome (inserted upside down into the liner) to push the ring down. The piston dome should be inserted into the liner, to the same depth as the ring being positioned. 2. For the oil control ring, insert the piston dome down into the liner, until the oil control ring land is just into the liner. This will ensure that the rings are parallel with the top of the liner, and that they are positioned in the liner within the normal area of ring travel. 3.
After the three rings have been positioned in the liner, measure the ring gap of the top ring with a feeler gage. See Figure 1-290. Remove the ring from the liner after the measurement is complete. Figure 1-290 Piston Ring Gap Measurement All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-313