1.21 PISTON AND CONNECTING ROD ASSEMBLY 3. Remove the oil pan. Refer to section 3.11.2. 4. For pre-1991 engines, disconnect and remove the lubricating oil pump inlet pipe and screen assembly, oil pump outlet pipe and lubricating oil pump. Refer to section 3.2.2. See Figure 1-295. NOTE: It is not necessary to remove the oil pump on 1991 and later model year engines. Figure 1-295 Oil Pump Removal (Pre-1991 Engines) 5. Remove the cylinder head. Refer to section 1.2.2. 6. Use an emery cloth to remove any carbon deposits from the upper surface of the cylinder liner. NOTICE:
If installed, remove the piston cooling nozzles from the base of the cylinder bores to prevent nozzle damage, during piston removal. 7. Remove the bearing cap and lower bearing shell from the connecting rod. 8. Install connecting rod guides (J–35945) (or equivalent) and oil nozzle protectors (J–43661)(or equivalent) to protect the crankshaft journals. 9. Push the piston and rod assembly out through the top of the cylinder block. NOTE: The piston cannot be removed from the bottom of the cylinder block. (Rev. 2005) All information subject to change without notice. 1-320 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION