SERIES 60 SERVICE MANUAL 10. Assemble the bearing cap and lower bearing shell to the connecting rod after removal. If not already marked, match-mark the rod and cap (on the tang side) with the cylinder number from where they were removed. See Figure 1-296. Figure 1-296 Connecting Rod and Cap Identification NOTE: When removed, the bearing cap and the bearing shell must be reinstalled on the original connecting rod before another connecting rod bearing cap is removed. NOTE: If removing the piston and connecting rod assembly to work on the cylinder liner, stop here. Refer to section 1.23.2 for cylinder liner removal procedure.
Remove the 14L and 12.7L EGR On-Highway cylinder liner, one-piece piston and connecting rod assembly as follows: 1. Drain the engine cooling system. Refer to section 14.6.4. 2. Drain the engine oil. Refer to section 14.6.1. 3. Remove the oil pan. Refer to section 3.11.2. 4. Remove the cylinder head. Refer to section 1.2.2. 5. Position the crankshaft journal for the cylinder kit assembly to be removed at bottom dead center. 6. Remove the bearing cap. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-321