1.21 PISTON AND CONNECTING ROD ASSEMBLY 7. Insert cylinder kit removal tool (J–45876) in the bore of the cylinder to be removed. Tighten the bolt snug. (Do not overtighten.). See Figure 1-297. Figure 1-297 Cylinder Kit Removal Tool (J–45876) 8. Install the oil nozzle protectors (J–43661). 9. Rotate the engine by hand until the entire cylinder kit assembly is pushed up where the liner can be removed by grabbing the tool to pull the kit completely out of the engine block. (Rev. 2005) All information subject to change without notice. 1-322 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION