SERIES 60 SERVICE MANUAL 10. Assemble the connecting rod bearing cap and lower bearing shell to the connecting rod after removal. If not already marked, match-mark the rod and cap (on the tang side) with the cylinder number from where they were removed. See Figure 1-298. Figure 1-298 Connecting Rod and Cap Identification NOTE: When removed, the bearing cap and the bearing shell must be reinstalled on the original connecting rod before another connecting rod bearing cap is removed. 11. Withdraw the piston and rod assembly through the bottom of the cylinder liner. NOTE: The rod will not fit through the inside diameter of the cylinder liner.
1.21.3 Disassembly of Piston and Connecting Rod Assembly Piston assembly components should be segregated by cylinder and match-marked during disassembly to ensure they are assembled in the same position and orientation. NOTICE: Stamping cylinder numbers on the piston assembly will damage the components. It is best to use a paint pencil. For cast iron pistons, mark the pin, skirt, bushing, and dome ear at the front. For forged steel pistons, mark the pin, skirt, and dome. For one-piece piston assemblies mark the pin and the dome/skirt assembly. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-323