1.21 PISTON AND CONNECTING ROD ASSEMBLY If the second ring on the cast iron piston is a rectangular section, the engine should be fitted with the current cast iron piston assemblies that contain a Second Keystone Ring (SKR) configuration. Former piston rings must NOT be used in the SKR configuration. Disassemble the cast iron piston and connecting rod assembly as follows: 1. Place the piston, dome down, on the round plate of the piston and connecting rod holding fixture (J–36211). See Figure 1-299. Figure 1-299 Piston Connecting Rod Holding Fixture 2. Slide the movable portion of the fixture until it contacts the piston pin and tighten the handle. 3.
Loosen the two bolts that secure the connecting rod to the piston pin and remove the two bolts and spacers. Discard bolts. 4. Remove the connecting rod. 5. Remove the piston, pin and skirt from the holding fixture. (Rev. 2005) All information subject to change without notice. 1-324 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION