Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL Disassemble the 12.7L and 14L forged steel piston and connecting rod assembly as follows: 1. Place the piston, dome down, on the table. See Figure 1-300. Figure 1-300 Positioning of the Piston and Connecting Rod Assembly 2. Using the required snap ring pliers, remove the circlip-type snap rings from the piston skirt. NOTE: For one piece piston assemblies skip to step 5. 3. Slide out the piston pin and remove the rod from the piston. 4. Disassemble the piston dome from the skirt. 5. Slide out the piston pin and remove the connecting rod from piston assembly. All information subject to change without notice. (Rev.

2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-325