Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.21 PISTON AND CONNECTING ROD ASSEMBLY 1.21.3.1 Inspection of Piston and Connecting Rod Assembly Refer to section 1.19.3 for disassembly of the piston and piston ring. Refer to section 1.19.3.1 for inspection of the piston and piston ring. Refer to section 1.22.3 for disassembly of the connecting rod. Refer to section 1.22.3.1 for inspection of the connecting rod. NOTE: Steel dome piston pin bearings and bushingless pin bores are not serviced. If they are found damaged then the replacement of the dome is required. The same is true for the rod bearings. If they are found damaged then the replacement of the rod is required as well.

1.21.4 Assembly of Piston and Connecting Rod Assembly Assemble the cast iron piston and connecting rod assembly as follows: NOTICE: The connecting rod-to-piston pin attaching bolts and spacers are specially designed components. No other bolts or spacers may be used. Piston pin bolts are considered one-use items and must be replaced with new bolts when removed for any reason. Failure to observe this precaution may result in bolt loosening or breaking during engine operation, which may cause serious engine damage. 1. Discard used piston pin bolts and replace with new bolts. 2.

Because of the low clearance fit between the piston pin and three-piece pin bearing, care in handling and cleanliness of piston dome bore, bearings, and piston pin are important. Otherwise, assembly may be impossible. The specifications on reusing piston assembly components are listed in Table 1-18 and listed in Table 1-21. 3. The pin bore and bearing backs should be wiped clean prior to installation of the bushings in the piston dome. 4. Installing piston pin bearings (with the piston dome standing on the rim) requires the upper bearing piece to be inserted through the end of the pin bore and dropped over the retaining pin. 5.

The lower bearing pieces are inserted flat side in by tilting the bearing at approximately a 30 degree angle from the vertical away from the dome ear. 6. Set the edge of the bearing parting line on the edge of the upper piece notch and rotate the lower bushing up and into place. The lower bearing can then be pushed full into the bore. 7. Lubricate the piston pin bearings with clean engine oil. (Straight 30 weight oil is recommended). (Rev. 2005) All information subject to change without notice. 1-326 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION