Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 8. Set the piston skirt on the piston dome. 9. Align the piston pin holes in the dome and skirt. 10. Check the piston pin for foreign matter in the bolt holes. 11. Lubricate the pin with clean engine oil and install in the bores with the bolt holes facing the connecting rod, away from the dome. NOTE: The piston pin may feel considerably tighter than with conventional designs and possibly may not be turned easily by hand. Proper pin and bearing installation should result in a piston assembly in which the pin can be turned with the connecting rod while the piston dome is standing on the rim and the piston skirt is held with the other hand. 12.

Apply a small amount of International Compound #2, or equivalent, to the bolt threads and bolt head contact surfaces and both ends of the spacers. NOTICE: The connecting rod-to-piston pin attaching bolts and spacers are specially designed components. No other bolts or spacers may be used. Piston pin bolts are considered one-time use items and must be replaced with new bolts when removed for any reason. Failure to observe this precaution may result in bolt loosening or breakage during engine operation, which may cause serious engine damage. 13. Install the spacers on the new connecting rod-to-piston attaching bolts. 14.

After clamping the connecting rod in holding fixture (J–36211), torque each piston pin bolt to 95-122 N·m (70-90 lb·ft). See Figure 1-299. 15. Complete the process by tightening the bolts to 150.2–163.8 N·m (110–120 lb·ft) final torque. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-327