1.21 PISTON AND CONNECTING ROD ASSEMBLY Assemble the forged steel piston and connecting rod assembly as follows: 1. Position the piston dome on its rim. See Figure 1-301. Figure 1-301 Positioning of Piston Dome NOTE: If piston is a one piece piston assembly proceed to step 4. 2. Place the piston skirt on the piston dome with the notches facing away from the dome. 3. Align the piston pin bores of the dome and skirt. 4. Liberally lubricate the piston pin bearings or bushingless pin bore in the dome and connecting rod bearing with clean engine oil. 5. Using the required snap ring pliers, install one of the circlip-type snap rings into the recess in the piston skirt.
Orient the snap ring gap to either the 12 o'clock or 6 o'clock position. 6. Lubricate the pin with clean engine oil. 7. Position the end of the connecting rod inside the piston dome. NOTICE: Do not mix piston pins in an engine. Failure to install the same piston pins in an engine may result in an unbalance condition indicated by severe vibration. Excessive vibration will have a detrimental effect on engine life. To avoid this situation, always check the part number on the end of the existing piston pin or measure the piston pin I.D. before installing the new pin. 8. Piston pins must not be mixed in an engine.
Install piston pin into the pin bores through rod until it rests against the previously installed snap ring. 9. Using the required snap ring pliers, install the other circlip-type snap ring into the recess in the piston skirt to lock the pin in place. Orient the snap ring gap to either the 12 o'clock or 6 o'clock position. (Rev. 2005) All information subject to change without notice. 1-328 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION