SERIES 60 SERVICE MANUAL 1.21.5 Installation of Piston and Connecting Rod Assembly To install the piston and connecting rod assembly into the engine (except 14L and 12.7 L EGR On-Highway engines), perform the following: 1. If the rings have been removed, install them onto the dome, refer to section 1.19.4. If the piston rings are installed, proceed to step 2. 2. Add clean engine oil to a clean pan at least 305 mm (12 in.) in diameter, until the level reaches approximately 76 mm (3 in.). 3. Place the piston and connecting rod assembly into pan, with the dome of the piston on the bottom of the pan. See Figure 1-302. 4.
Coat the piston liberally with the engine oil, saturating the piston rings and lands. Figure 1-302 Piston and Connecting Rod Assembly Lubrication All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-329