Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.21 PISTON AND CONNECTING ROD ASSEMBLY NOTICE: Do NOT force the piston into the liner. The oil ring expander applies considerable force on the oil ring. Therefore, care must be taken during the loading operation to prevent ring breakage. 16. Push the piston and connecting rod assembly down into the liner until the piston is free of the ring compressor. 17. Remove the piston ring compressor. 18. Push or tap the piston and connecting rod assembly into the liner, turning the rod, if necessary, until the upper bearing shell is firmly seated on the appropriate crankshaft journal. 19. Remove the connecting rod guides from the ends of the connecting rod bolts and remove oil nozzle protectors. NOTE:

Be sure the connecting rod bolts have not been unseated or turned and the bearing locating tang is in its proper location. 20. Place the lower bearing shell in the connecting rod cap, indexing the tang on the bearing with the notch in the cap. 21. Lubricate the bearing shell with clean engine oil. 22. Install the bearing cap. The number on the cap and rod should be on the same (oil cooler) side. See Figure 1-310. Figure 1-310 Connecting Rod and Cap Identification (Rev. 2005) All information subject to change without notice. 1-336 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION