SERIES 60 SERVICE MANUAL 23. Torque the connecting rod bolts alternately to 160-185 N·m (118-137 lb·ft). 24. Check connecting rod side clearance by moving the rod from crank cheek to crank cheek. If there is no clearance, check for proper bearing cap installation. 25. Install the remaining piston and rod assemblies in the same manner. 26. Install a new head gasket. Refer to section 1.2.5. 27. Install the cylinder head. Refer to section 1.2.5. 28. If previously removed, install the piston cooling nozzles at the base of the cylinder bores. 29. Install the lubricating oil pump inlet pipe and screen assembly, and the lubricating oil pump. Refer to section 3.2.6. 30. Install the oil pan.
Refer to section 3.11.4. 31. Complete any other engine assembly as necessary. 32. After the engine has been completely assembled, refill the crankcase to the proper level on the dipstick. Refer to section 14.6.1. 33. Close the drain cocks and fill the engine with the recommended coolant. Refer to section 14.6.4 for refilling procedure and refer to section 5.4. NOTE: Coolant system maintenance is very important. Bleed off all the air from the system and top off. 34. Perform the following steps for verifying repairs made to the piston and connecting rod assembly: [a] If new parts such as pistons, rings, cylinder liners or bearings were installed, operate the engine on the run-in schedule.
Refer to section 12.7.3.2. [b] If used parts such as pistons, rings, cylinder liners or bearings were installed, refer to section 12.3 for verification of proper piston and connecting rod assembly installation. Install the 14L and 12.7 EGR On-Highway liner, one-piece piston assembly and connecting rod assembly as follows: 1. If the rings have been removed, install them onto the dome, refer to section 1.19.4. If the piston rings are installed, proceed to step 2. 2. Add clean engine oil to a clean pan at least 305 mm (12 in.) in diameter, until the level reaches approximately 76 mm (3 in.). 3.
Place the piston and connecting rod assembly into pan, with the dome of the piston on the bottom of the pan. See Figure 1-311. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-337