Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.21 PISTON AND CONNECTING ROD ASSEMBLY 4. Coat the piston liberally with the engine oil, saturating the piston rings and lands. Figure 1-311 Piston and Connecting Rod Assembly Lubrication 5. Remove assembly from pan and position (stagger) the piston ring gaps properly on the piston at 90 degree intervals. See Figure 1-312 for diesel engines. Figure 1-312 Piston Ring Positioning (Diesel) 6. Coat the inside diameter of the ring compression tool (J–43397) liberally with clean engine oil from the pan. 7. Coat the inside diameter of the ring compression tool (J–46927) for 12.7L engines and (J–46929) for 14L engines with clean engine oil. 8.

Clamp the ring compressor, with groove (pilot bore) of the compressor facing away from the connecting rod, around the dome and rings. (Rev. 2005) All information subject to change without notice. 1-338 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION