SERIES 60 SERVICE MANUAL 9. Once the compressor is "clamped," ensure the piston can rotate freely. If rotation is hindered, remove the compressor and reposition the dome and rings, or inspect for ring damage. 10. Lubricate seals with clean petroleum jelly and install on cylinder liner. 11. Lubricate the inside of the cylinder liner. 12. Position the liner so it rests on its flange. 13. Position the ring compressor clamped around the dome and rod assembly so the groove rests on the bottom of the cylinder liner. See Figure 1-313. Figure 1-313 Installation of Ring Compressor for One piece Piston Assembly All information subject to change without notice. (Rev.
2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-339