Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.21 PISTON AND CONNECTING ROD ASSEMBLY NOTICE: Do NOT force the dome into the liner. Considerable force on the dome could scratch or otherwise damage the inside of the cylinder liner. Therefore, care must be taken during the installation of the dome to prevent damage. 14. With care and moderate pressure, press the dome into the liner until the dome is approximately half way into the liner. See Figure 1-314. 1. Cylinder 2. Connecting Rod Figure 1-314 Installation of Piston and Rod Assembly 15. Remove the ring compressor. 16. Remove the cap from the connecting rod. 17. Install oil nozzle protectors (J–43661). 18.

Position the throw of the crankshaft journal to bottom dead center for the cylinder being installed with the liner, piston and connecting rod assembly. (Rev. 2005) All information subject to change without notice. 1-340 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION