Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL NOTICE: When installing a forged steel piston into the engine, care must be taken to avoid damaging the piston-cooling nozzle installed at the base of the cylinder bore. Before loading the piston/rod liner assembly into the block, turn the connecting rod so that the bearing end is offset approximately 10-15 degrees and not perpendicular to the crankshaft, as is the case with cast iron pistons. This will ensure that the rod end does not strike the nozzle when the piston is pushed in the cylinder liner. Once the rod end is past the nozzle, turn the rod so that the bearing end is perpendicular to the crankshaft journal. NOTICE:

Failure to orient the piston connecting rod properly during forged steel piston installation may result in the bearing end of the rod striking the nozzle, causing damage to the nozzle or loosening it from the block. A damaged, bent, or loosened nozzle may cause a loss of main gallery pressure. In these cases piston overheating or lack of adequate lubrication may result in severe engine damage. 19. Ensure arrow on piston dome is pointing toward the front of the engine during installation. See Figure 1-315. Figure 1-315 Piston Dome One Piece Piston Assembly All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-341