1.21 PISTON AND CONNECTING ROD ASSEMBLY 20. Slide the cylinder kit assembly into the cylinder block noting the position of the connecting rod to ensure the rod is assembled to the same position as it was when removed. Push by hand until resistance is felt. See Figure 1-316. Figure 1-316 Installation of Liner, Piston and Rod Assembly into Engine Block 21. Install cylinder liner installer (J–35597–A) over the kit to be installed. See Figure 1-317. NOTE: It is necessary to leave the cylinder kit installation tool in place until after the liner protrusion is measured. Figure 1-317 Cylinder Liner Installation Tools (Rev. 2005) All information subject to change without notice.
1-342 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION