Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL 22. Thread three cylinder head bolts through the tool and into a head bolt hole, so that the round shoe of the tool is centered over the liner. Alternately tighten the three bolts until they are tight. NOTE: It is not necessary to torque the bolts. 23. Turn the threaded center bolt in a clockwise direction. As the round shoe of the tool reaches the liner, ensure that the shoe is properly positioned into the cylinder liner. NOTE: Use care for proper rod positioning during installation. 24. Continue turning the bolt until the liner bottoms in the cylinder counterbore. Apply a tightening torque of 60 N·m (44 lb·ft) to the installation tool center bolt. 25.

Install a dial indicator sled gage. See Figure 1-318. 26. Measure the distance from the top of the liner flange to the top of the block. See Figure 1-318. [a] Allowable liner protrusion is -0.0127-(+0.076) mm (-0.0005 -(+0.003 in.)) with no more than 0.0508 mm (0.002 in.) variation between any two adjacent cylinders. Specifications are listed in Table 1-17. [b] If the liner protrusion exceeds the maximum allowable, remove the kit and check for debris under the liner flange. Figure 1-318 Cylinder Liner Protrusion 27. Remove the cylinder liner tool. 28. Push or tap the piston and connecting rod within the liner until the upper rod bearing is firmly seated on the appropriate crankshaft journal. 29.

Remove the oil nozzle protectors. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-343