1.22 CONNECTING ROD 1.22.2 Removal and Cleaning of the Connecting Rod Before removal, make sure the connecting rods and caps are stamped with their correct cylinder location. If not marked, stamp location (1-6) on the tang side (cooler side) of the rod and cap. Refer to section 1.21.2 for piston and connecting rod assembly removal procedure. 1.22.3 Disassembly of Connecting Rod Disassemble the connecting rod as follows: NOTE: It is best to disassemble, inspect and assemble each connecting rod separately. It is very important to keep the connecting rod cap, and the upper and lower bearing shells to the original connecting rod. 1. Loosen and remove the two connecting rod nuts.
See Figure 1-319. 2. Remove connecting rod cap and bearings shells. See Figure 1-319. 1.22.3.1 Inspection of Connecting Rod Clean the bearings prior to inspection as follows: 1. Clean the bearings with fuel oil. EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. 2. Dry the bearings with compressed air. Inspect the open-end connecting rod as follows: 1. Inspect the connecting rod saddle at the piston pin contact surface for traces of fretting and corrosion. 2. To repair, wet with fuel oil and smooth with crocus cloth. (Rev.
2005) All information subject to change without notice. 1-354 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION