Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

SERIES 60 SERVICE MANUAL Inspect the closed-end connecting rod as follows: NOTICE: Reusing a connecting rod with a damaged or loose bushing may result in severe cylinder kit damage. 1. Inspect the piston pin bushing for indications of scoring. If scoring is found, replace the rod. 2. Inspect the piston pin bushing for indications of overheating. A bushing that has overheated may become loose. If a loose bushing is found, the rod must be replaced. 1.22.4 Assembly of Connecting Rod Assemble connecting rod as follows: 1. Install the connecting rod cap with the numbers on the same (oil cooler) side on the connecting rod. 2. Lubricate the bolt threads with clean engine oil. NOTICE:

Do not over torque the connecting rod bolt nuts. Over torque may permanently distort the connecting rod cap. Be sure the connecting rod bolt has not turned in the connecting rod before torque is applied to the nut. NOTICE: 3. Torque the bolt nuts to 160-185 N·m (118-137 lb·ft). All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-355