Detroit Diesel — Print Preview - C:\DOCUME~1\llakso01\LOCALS~1\Temp\.aptcache\S600507006\S600507

1.22 CONNECTING ROD 1.22.4.1 Inspection of Assembled Connecting Rod Measure the connecting rod bearing diameter at five locations. See Figure 1-326. Figure 1-326 Dimensional Inspection of Connecting Rods 1. Calculate size of diameter at split line, W. [W= (A+B) ч 2] 2. Calculate the average bore out-of-round, X. [X=W-C] X must be between -0.012 and 0.012 mm (-0.0005 and 0.0005 in.). 3. Calculate the average connecting rod bearing bore size, Y. [Y= (W+X) ч 2] Y must be between: [a] For 12.7 and 11.1 L; 91.288 and 91.313 mm (3.594 and 3.595 in.). [b] For 14L and 12.7 EGR On-Highway; 101.288 and 101.3133 mm (3.988 and 3.989 in.). (Rev. 2005) All information subject to change without notice.

1-356 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION