SERIES 60 SERVICE MANUAL 4. Determine taper, Z. [Z=D2-D1] Z must be between -0.012 and 0.012 mm (-0.0005 and 0.0005 in.). 5. Determine the rod length by finding the distance between E1 and E2. See Figure 1-326. [a] The acceptable rod length specification for 11.1 Liter connecting is: 281.95-282.05 mm (11.1004-11.1043 in.). [b] The acceptable rod length specification for both 12.7 Liter and 14 Liter connecting rods is: 269.25-269.35 mm (10.6004-10.6043 in.). [c] The acceptable rod length specification for Series 60G Engines is: 262.90-263.00 mm (10.3504-10.3543 in.). [d] If the connecting rod bore is not to specifications, the rod must be scrapped and cannot be machined. 6.
If a new connecting rod is required, stamp the cylinder number on the connecting rod and cap. Refer to section 1.21.3. 1.22.4.2 Inspection of Connecting Rod Bearings and Bearing Bores Inspect the connecting rod bearing as follows: EYE INJURY To avoid injury from flying debris when using compressed air, wear adequate eye protection (face shield or safety goggles) and do not exceed 276 kPa (40 psi) air pressure. 1. Check connecting rod bearing wear surfaces for scoring, pitting, flaking, chipping, cracking, loss of overlay, or signs of overheating. [a] Overlay plated bearings may develop very small cracks or small isolated cavities ("checking") on the bearing surface during engine operation.
These are characteristics of and are NOT detrimental to this type of bearing. The bearings should not be replaced for these minor surface imperfections. The upper bearing shells, which carry most of the load, will normally show signs of distress before the lower bearing shells do. If the overlay is worn through to the copper across the bearing shell, all the bearing shells must be replaced. [b] If any of these conditions are detected, replace the bearings. All information subject to change without notice. (Rev. 2005) 6SE483 0507 Copyright © 2005 DETROIT DIESEL CORPORATION 1-357